Polycom IP 335 Setup Notes

Setup on the IP PBX

Click through on the following menu options:

Admin -- Change system Configuration
Add -- Add IP Phone
Enter Station -- ###
Enter Description --
Enter IP Address --
Enter MAC Address from the Phone --
Branch where phone is located --
Operator Group --
Trunk Group --
Check Mark RFC 2833 --
If remote worker -- Click send packet to server

===================================================
Polycom SoundPoint IP 335 Setup Notes
===================================================

ASSEMBLE PHONE

1. Completely assemble the phone.
2. Plug Power Over Ethernet outlet
3. Power it up

===================================================

INITIAL PHONE SETUP

4. Enter Phone IP Address, Subnet Mask:

Press EDIT, use the STAR key for a dot in IP addresses.
Press OK. "del" button will backspace.

5. Enter Subnet Mask:

Press EDIT, use the STAR key for a dot in IP addresses.
Press OK. "del" button will backspace.

6. Enter IP Gateway (default route).

Press EDIT, use the STAR key for a dot in IP addresses.
Press OK.

7. Select the Server Menu

Select FTP Server Address.
Press EDIT, enter the FP server IP address - use the STAR key for a dot in IP addresses.
press OK.

8. Scroll down to the SNTP (Time) server address.

Press EDIT.
Press the softkey labeled "a->1A" to get "1->Aa" for numeric input.
Enter FacetPhone server IP address.
PRESS OK.

9. Select the GMT Offset:

Press EDIT. Scroll left or right (-6 = CST).
Press OK.

10. Turn off CDP.

Select the ETH menu.
Select CDP.
Press EDIT.
Right arrow to disable.
Press OK.
Press EXIT.

or

CDP is on the top level.
Press EDIT.
Right arrow to disable.
Press OK

11. Press EXIT

12. Press EXIT

13. Plug Polycom 335 into the network.

14. Press SELECT to Save Configuration & Reboot.

===================================================